PROFESSIONAL INSTALLATION REQUIRED!
DO NOT USE A BATTERY CHARGER, JUMP BOX, CORDLESS BATTERY . ONLY USE A 12 VOLT CAR BATTERY OR MARINE BATTERY!
THE CLEAR OR (WHITE) ICE CUBE HAS TO BE USED. ONE FOR EACH LIGHT. THE SHORT WIRE ON THE CUBE GOES TO THE LIGHT!
SOME OF THE DESCRIPTIONS IN THIS VIDEO DO NOT APPLY TO ALL THE LIGHTS, WATCH THE ENTIRE VIDEO IF YOU ARE HAVING A PROBLEM, PARTS OF THIS VIDEO APPLY TO ALL THESE PARTICULAR LIGHTS AT SOME POINT!
SEE FURTHER INSTRUCTIONS IN THE VIDEO AND AT THE BOTTOM OF THE PAGE
THERE IS NO WAY THE LIGHT ITSELF DOESN'T WORK, YOU HAVE SOMETHING CONNECTED WRONG. (nothing personal, but we are that confident)
THEY ARE TESTED 3 TIMES BY 3 DIFFERENT PEOPLE THEN TESTED ONCE MORE BEFORE THEY ARE PLACED IN THE BOX!
Built in Texas, by Texans
Typhon / Y-knot
HEY L@@K---DO NOT USE THE LIGHT WITHOUT THE LED DRIVER (clear ice cube) IN PLACE
PROFESSIONAL INSTALLATION REQUIRED NEED MORE INFO?
WWW.UWANTHELP.COM CLICK ON YOUR LIGHT
**PROPER FITMENT OF THIS PRODUCT IS UP TO THE INSTALLER
REGARDLESS OF PRIOR COMMUN/CATIONS OF ANY TYPE**
MAKE SURE THE LIGHT CLEARS YOUR LOWER UNIT BEFORE ANYTHING ELSE!
Professional installation REQUIRED: USE A FUSE WITHIN 18” OF YOUR POWER SOURCE. CONTACT US WITH FUSE REQUIREMENTS IF YOU NEED TO.
SINGLE LED, 3 AMP. TWO OR THREE leds PARALLED REQURE A 5 AMP FUSE.
DO NOT LEAVE L.E.D. ON OUT OF THE WATER
THE CONSTRUCTION OF THIS LIGHT REQUIRES THAT IT BE KEPT COOL IN THE WATER. THIS LIGHT IS TO BE USED SUBMERGED OR SPLASHED ON, THEY CAN NOT BE USED "HIGH AND DRY"
1) With the boat out of the water, remove your old 1/2" NPT boat plug.
2) Install new plug it will not bottom out. NPT plugs have tapered threads
3) Route the wires to your power source (stern lights are a great power point!)
4) Strip the wires back on each black and red on the driver and the light, matching up color for color (short wire on driver/clear cube, goes to the light) and twist the wires together. .
if you can 't reach your wires from the inside, get a coat hanger, " fish" tape or
even a thin piece of cable and run it through your drain from the outside.
Pulling the wires to you from the outside of the boat THEN connect it together.
DO NOT USE THE LIGHT WITHOUT THE LED DRIVER IN PLACE
TEST THE LIGHT BEFORE ITS INSTALLED TO CHECK OPERATION & COLOR
DO NOT USE A "JUMP BOX" OR BATTERY CHARGER,
USE A 12V CAR OR MARINE BATTERY
If you purchased a remote control make sure the receiver end of the remote,
that says "LED" is the OUTPUT to the light.
DO NOT USE THIS LED LIGHT BELOW HULL LINE (BOTTOM OF YOUR BOAT).
We advise that you use TEF-GEL on ALL FITTINGS
YOU CAN UPGRADE YOUR LIGHT PIECE BY PIECE ON OUR WEBSITE.
YOUR SINGLE LIGHT WILL WORK WITH OUR YKNOT ADAPTER.
BUY l OR 2 MORE LIGHTS TO GET AROUND THAT OUT-DRIVER
IF YOU ARE KEEPING THE BOAT IN SALTWATER YOU NEED TO USE TEF-GEL ON ALL THE
THREADS.ALWAYS A GOOD IDEA TO USE TEFLON TAPE OR PTFE PASTE ON THE THREADS IN FRESHWATER
(terms, conditions and disclaimers available for view at boatpluglight.com)